When a faucet or valve leak is an emergency
A slow drip from a spout is not urgent. A broken supply line, a cracked angle stop or a shower valve that will not close is. Water under a sink or behind a tub wall can run for hours before anyone notices, and it soaks cabinets and drywall quickly.
If the shutoff under the sink will not turn, do not force it. Close the main valve at the house and call us. We take these calls at night, on weekends and on holidays, and a same-day visit is available when we have an opening.
The fixtures we repair most
| Fixture | Common problem | Usual repair |
|---|---|---|
| Kitchen faucet | Drip, spray head failure, loose base | Cartridge or aerator, supply lines |
| Bathroom sink faucet | Drip at spout or handle | Cartridge or seat replacement |
| Tub and shower valve | Will not shut off, leaks behind the wall | Cartridge, trim or valve body |
| Angle stop and shutoff valve | Stuck, leaking at the stem | Replace the valve |
| Supply line | Cracked braid, loose nut | Replace the line |
Many drips are a worn cartridge or washer and cost little to fix. A body that is corroded or cracked needs replacing.
California sets maximum flow rates for new faucets under CALGreen and state appliance standards, so a replacement aerator or faucet should match the rated flow of the original.
Shower and tub valves
Shower valves hide inside the wall. A handle that drips after being turned off usually has a worn cartridge, and swapping it takes a short visit. If the valve will not close at all, or water appears at a ceiling below, the valve body may be damaged and an opening in the wall is needed.
A shower or tub that drains slowly is a drain question, not a valve question, and is handled on our drain cleaning page.
Faucet or valve leaking?
Call (626) 898-6169. We repair fixtures and valves day or night and book same-day when available.
Shutoff valves and why old ones fail
Under-sink shutoffs are the valves most people forget until they need them. Many are old multi-turn valves with rubber washers that harden. When someone finally turns one, it breaks, or it will not seal after the repair.
We replace tired valves with quarter-turn ball valves, which close fast and are easier to use in an emergency. If every shutoff in the house is original, replacing them in one visit also makes later repairs easier. For a faucet or fixture that also has a ruined supply pipe, see burst pipe repair.
What hard water does to faucets in Temple City
Golden State Water's South Arcadia system reported an average hardness of 160 mg/L in 2025, and its South San Gabriel system averaged about 240 mg/L. In water of that kind, mineral scale clogs aerators, roughens cartridge seats and makes handles stiff.
That is why a faucet that is a few years old can drip when it should not. Cleaning an aerator is a quick maintenance task, and replacing a cartridge restores the seal. A water filtration or softening system lowers the scale at the source, and the choices are covered under water softener and filtration.
Houses built in the 1950s often still have their original angle stops, and 30.6 percent of Temple City's homes come from that decade.
What decides the price of faucet and valve repair
Want your real number? Call (626) 898-6169 and describe the fixture. The plumber states the price before work starts.
Questions we get asked
Yes. The line at (626) 898-6169 is open 24/7. If a valve or supply line is leaking, close the main valve and call, and we book a same-day visit when we have an opening.
Old valves seize from mineral buildup. Do not force it. Close the main valve and call, and we replace the valve.
Usually yes. A drip wastes water and often means a cartridge that will fail further. Replacing it is a short job.
If it is a cartridge problem, often yes. A cracked valve body needs an opening in the wall or an access panel from the other side.
Turn the angle stop clockwise. If it will not close, turn off the main valve. Then call us to replace the line.
