Plumber kneeling in a wet basement repairing a leaking pipe next to a water heater

Emergency Burst Pipe Repair in Temple City, CA

A burst pipe can put hundreds of gallons into a house in an hour, and (626) 898-6169 is open 24/7 for exactly this. Close the main water valve first, switch off power near the wet area and call us, and a licensed plumber will come to your Temple City address.

24/7 Emergency Line Open

Burst pipe: the first five minutes

Speed matters more than anything else on a burst pipe. The main shutoff is usually at the street meter box or where the supply enters the house. Turn it clockwise until it stops, then open a faucet at the lowest point to drain what remains.

1Close the main valveFind it at the meter or where the line enters the house.
2Cut power if water is near itSwitch off the breaker for wet areas and stay out of standing water.
3Move belongingsLift rugs and furniture and put towels at doorways.
4Call and photographCall (626) 898-6169, then photograph the damage for your insurer.

Same-day service is available when we have an opening, and our dispatcher will stay on the line until you have the water off.

Why pipes burst in a mild climate like Temple City

Freezing is rare in Temple City, so the usual cause is not a hard frost. In houses here, bursts and cracks come from corrosion, pressure and age. Galvanized steel rusts from the inside until a wall gives way. Copper develops pinholes. A joint made decades ago finally lets go.

Pressure plays a part too. A failed or missing pressure regulator pushes more stress into every fitting, so we check the static pressure with a gauge as part of the repair visit.

Fast repairs are one part of the answer. If a burst was caused by pipe condition, another one will follow, which is why we also look at how many other weak points the line has.

Safety comes first. If water has reached outlets, lights or the panel, stay out of the water and switch off power only if you can reach the switch while dry. This is what to do before we arrive when electricity is involved.

How we repair a burst pipe

We shut off the water, locate the break, cut out the damaged section and replace it with new pipe and fittings. Where the pipe is copper, we use soldered or compression fittings as the code allows, and where it is PEX we use approved crimp or expansion connections.

Then we pressure-test the repair, restore water slowly and check nearby joints. We also tell you what we saw in the rest of the line. When the pipe is badly corroded, a spot fix can be a short-term answer and repiping the affected run is the better long-term one.

Water pouring out of a pipe?

Call (626) 898-6169. Close the main valve, then let us send a plumber. Same-day when available.

Call (626) 898-6169

Common causes and the usual fix

Burst pipe causes found in older California homes
PipeTypical failureUsual repair
Galvanized steelInternal rust, thin wall, split at threadsReplace the run, often with copper or PEX
CopperPinhole corrosion or a failed solder jointCut out and replace the section
PEXDamaged fitting, UV exposure or impactReplace the fitting or a short piece
Plastic and CPVCBrittle cracks, heat or overtightened fittingsCut out and replace with new fittings

What we see in Temple City homes

The city's housing element shows that 57.7 percent of Temple City homes are over 60 years old, and the 1950s are the single largest decade at 30.6 percent. A supply line installed then has already had decades of service, and in some houses it has been patched more than once.

Hard water speeds that wear. Golden State Water's South San Gabriel system reported an average hardness of 240 mg/L in 2025. Scale builds inside pipes and corrosion pits the metal under it.

A leak you have not found may be the pipe about to burst, so a leak that has been dripping behind a wall is worth tracking down with leak detection before it fails. If the leak is between the meter and your house, see our water service line repair page.

Water damage and your insurer

A burst pipe is usually a covered event under standard homeowner policies for the damage it causes, though the pipe itself is not. Photograph everything before cleanup, keep receipts and report quickly.

We can give you a written description of what failed and what we repaired, which helps with the claim. Ask your insurer about drying and mitigation help for anything beyond the plumbing.

What decides the price of a burst pipe repair

Pipe materialCopper, galvanized, PEX and CPVC each need different parts and methods.
LocationA pipe in an open garage is easy. One inside a finished wall is not.
Length of damageA short split and a long corroded section are very different jobs.
Hour of the callAfter-hours calls are priced differently from daytime visits.
Follow-up workOpening a wall means patching and paint, which is a separate trade.

Want your real number? Call (626) 898-6169 and describe where the pipe is. The plumber states the price before work starts.

Questions we get asked

Yes. The line at (626) 898-6169 is open 24/7, including holidays. Dispatch stays on the phone until the water is off and books the earliest same-day visit available.

Most houses have a valve at the street meter box and another where the line enters the house, often near the front hose bib or on the side of the garage. Clockwise closes it. If you cannot find it, call us and we will help over the phone.

Standard homeowner policies commonly cover the resulting water damage but not the pipe itself, and rules differ by policy. Photograph everything, keep receipts and ask your insurer directly.

Pipes fail from corrosion, high pressure, old fittings and movement as well as freezing. In Temple City's older houses, aged galvanized and copper lines are the main reason.

Not always. If the rest of the line is in good shape, a repair is fine. If we find widespread corrosion or the same pipe has failed more than once, repiping is worth pricing.

Where we work: Temple City and nearby cities

Call (626) 898-6169 24/7